Section 4: Navigating Menus; Introduction - Honeywell HD6 Series User Manual

4.1

INTRODUCTION

The HD6 features on-screen menus for simplifying set up and for enabling special
features available for customer use. All units are set up at the factory; but can be easily
changed in the field using the on-screen menus. Refer to your system controller user
manual for the keystrokes to access the HD6 setup menu and the keystrokes to navigate
through the options.
The controller must meet the following requirements:
• The HD6 being setup must be selected as the control camera on the controller
where the keyboard is connected.
The video from the scan must be displayed on the control (spot) monitor.
•
• The controller must have manual control of the scan.
Examples:
• When using an HJZTP/HJZTPX controller, press and hold the Lock key, then press
F6 (menu) to display the HD6 menus on the controller's LCD. While SETUP is
flashing on the LCD, press the aux key. The setup menus are displayed on the
monitor.
• When using the HEGS5000/HEGS5001 controller, press the Dome Menu key.
Press +/- until Dome Setup Menu is displayed on the LCD, then press Enter (
to access the HD6 setup menu. Use the numeric keys to access the menu options.
Press Clear/Manual (
menu.
Press the Dome Menu Key to exit the HD6 menu mode on the HEGS5000 controller.
When using the HSX3208 and an HEGS5002 controller,
•
press Aux (
menu.
Use numeric keys on the controller to access menu options.
Press Flashback (
menu.
Press Back (
operation.
• When using a Honeywell Maxpro mode, Honeywell VCL, Pelco P, or Pelco D
controller send the scan to PreShot 90. When using an American Dynamics
controller, send the scan to PreShot 61. To select a menu option when using these
controllers, use the tilt up and down function on the controller to move the cursor to
the desired number beside the option, then press Iris Open. The pan left and right
commands may also be used to move horizontally between fields in a table. The
Iris Close function is used to exit (Esc to exit) menus.
Rev. 1.02
SECTION 4:
NAVIGATING MENUS
) to send an Esc command to the HD6 and exit the HD6
), then PTZ Call (
) to send an Esc command to the HD6 and exit the HD6
) to exit the menus on the HEGS5000 LCD and return to normal
19
) then Enter ( ) to access the HD6 setup
)
900.0679
22-June-2006