Programming Ptz Tours; Ptz Tour Operation - Honeywell HD6 Series User Manual

7.6

PROGRAMMING PTZ TOURS

Three (3) PTZ tours can be programmed using on-screen menus. Refer to
for programming tours. Each tour is a maximum of 2 minutes (120 seconds). When a
PTZ tour is run, the scan performs the pan, tilt, zoom, and focus commands that were
performed during the PTZ tour programming mode.
Some controllers such as the HEGS5000 feature LCD menus that allow the operator to
start tours from the controller without accessing the HD6 on-screen menus. Refer to
your specific controller manual for starting tours.
7.7

PTZ TOUR OPERATION

A PTZ tour can be started from the on-screen menu (refer to
controllers such as the HEGS5000 feature LCD menus that allow the operator to start
tours from the controller without accessing the HD6 on-screen menus. Refer to your
specific controller manual for starting tours.
Rev. 1.02 94
Section 5.7.1
Section 5.7.1). Some
900.0679
22-June-2006