Vectorscans (Video Tour); List Programmed Vectorscans; List Contents Of A Vectorscan; Run Vectorscan - Honeywell HD6 Series User Manual

8.7

VECTORSCANS (VIDEO TOUR)

Using a Honeywell Maxpro, Honeywell VCL, Pelco P code, or Pelco D Code Controller,
ten (0-9) VectorScans can be programmed using the setup menu accessed by the
PreShot 90 command. Refer to

8.7.1 List Programmed VectorScans

VectorScans must be programmed through the setup menu. Refer to

8.7.2 List Contents of a VectorScan

VectorScans must be programmed through the setup menu. Refer to

8.7.3 Run VectorScan

VectorScans 1, 2, and 3 can be started from the system controller using PreShot
commands 87, 88, and 89.
Example: To start VectorScan 2, send a PreShot 88 command.
VectorScans 0 and 4 - 9 can be assigned to alarms or the default function.
When a scan receives a command to run a VectorScan, the scan goes to the first
PreShot programmed in the VectorScan at maximum velocity (400°/second) for the
programmed dwell time, then goes to the next PreShot in the VectorScan at the
programmed velocity for the specified dwell time, etc. When a VectorScan is running
continuously, the unit goes from the last PreShot to the first PreShot at the programmed
velocity. The amount of time the scan takes to go to each PreShot depends on the
programmed velocity and the distance to the next PreShot's pan and tilt coordinates.
The velocity is programmable between 1° to 400° per second.
If:
VectorScan auto focus is ON
VectorScan auto focus is OFF
Rev. 1.02
CAUTION: Continuous VectorScan operation for
extended periods of time (> 8 hours) is not
recommended. Continuous operation results in
increased zoom lens failure and maintenance
expense.
Section 5.7.2
Then:
If the VectorScan auto focus feature is
ON, the lens auto focuses when going
to each PreShot (and for a short time
afterwards) then it does not auto focus
until the HD6 goes to the next
PreShot.
The lens focuses to the focus setting
programmed for each PreShot.
99
for programming VectorScans.
Section 5.7.2.
Section 5.7.2.
900.0679
22-June-2006