Equipment Handling; Domes; Hd6 Assembly; Camera Lens - Honeywell HD6 Series User Manual

1.2

EQUIPMENT HANDLING

1.2.1 Domes

It is extremely important to treat the surface of all domes (smoked and clear) with the
same care as you would a fine camera lens.
• Always handle the dome from its outside surface.
• Refer to
• Only use non-abrasive cleaners for acrylic plastic on the clear and smoked domes.

1.2.2 HD6 Assembly

The HD6 consists of:
1. the pan and tilt mechanism;
2. camera with zoom lens;
3. power supply board
4. digital receiver board; and
5. video board.
Do not attempt to remove the camera from the scan assembly. If a camera or lens
requires service, the entire scan assembly must be sent back to the factory.
CAUTION: The receiver board and power supply board on the scan
assembly have static sensitive devices. The HD6 assembly is shipped in
a pink bag that is static dissipating. The unit should be handled in this
bag until installed. If the unit is shipped, it must be shipped in the
pink bag or an equivalent static dissipating enclosure.

1.2.3 Camera Lens

• Handle the camera lens with extreme care.
• Never touch the lens surface.
• Refer to
Rev. 1.02
Section 13 - Maintenance
Section 13 - Maintenance
for dome cleaning procedures.
for information on cleaning the camera lens.
2 900.0679
22-June-2006