Crosshairs; Control Options; Pass; Auto-Pivot - Honeywell HD6 Series User Manual

5.2 DISPLAY OPTIONS, CONTINUED

5.2.8 Crosshairs

From the DISPLAY OPTIONS menu, select 8 to display crosshairs on the display.
This is useful when using Pan Offset.
Select 3 from the MAIN MENU to set control
options. Control of a Scan assembly includes
pan, tilt, zoom, focus, and iris.
Refer to the controller user's manual for
operation of the controller to perform these
functions.
5.3

CONTROL OPTIONS

5.3.1 PASS

If the PASS function is enabled, the pan and tilt
speed range is a function of the lens zoom
angle. As the lens is zoomed in, the maximum
pan and tilt speeds are reduced and the low
speed control is expanded.
Note: At 12X zoom, the scan moves very slowly.
To enable/disable PASS, select 1 to toggle
between ON (enable) and OFF (disable).

5.3.2 Auto-Pivot

If the Auto Pivot feature is enabled, the pan
and tilt unit automatically pans the camera
180° when the camera reaches vertical. This
feature is used to assist the operator in
tracking an individual that passes directly
under the camera.
To enable/disable Auto-Pivot, select 2 and
toggle between ON (enable) and OFF
(disable).
Rev. 1.02
1 Language............... English
2 Display Options
3 Control Options
4 Diagnostic Options
5 Camera Options
6 Function Programming
ESC to Exit
1 PASS ....................................ON
2 Auto-Pivot .............................ON
3 Program Alarms
4 Set Pan and Tilt Options
5 Set Default Function
6 Auto Focus .............................. Z
7 VectorScan Auto Focus ..... OFF
ESC to Exit
1 PASS ........................................ON
2 Auto-Pivot.................................ON
3 Program Alarms
4 Set Pan and Tilt Options
5 Set Default Function
6 Auto Focus.................................. Z
7 VectorScan Auto Focus......... OFF
ESC to Exit
29
---- UltraDome ----
HD6
519543-1980
CONTROL OPTIONS
CONTROL OPTIONS
900.0679
22-June-2006