5.3
CONTROL OPTIONS, CONTINUED
VectorScan auto focus is ON
VectorScan auto focus is OFF
5.4
DIAGNOSTIC OPTIONS
Select 4 from the MAIN MENU to access
Diagnostic Options. Diagnostic menus are
designed for assisting service technicians in
troubleshooting.
Refer to the controller user's manual for
operation of the controller to perform these
functions.
5.4.1 Coordinates
Select 1 to turn the Pan and Tilt Coordinates
display ON or OFF.
When you exit programming, the coordinates
are displayed. The pan and tilt coordinates
are displayed in degrees
Rev. 1.02
If:
The lens auto focuses when going to a
PreShot while running a VectorScan.
The lens goes directly to the focus position
stored for each PreShot while running a
VectorScan. It does not autofocus.
37
Then:
---- UltraDome HD6 ----
519543-1980
1 Language ............................... English
2 Display Options
3 Control Options
4 Diagnostic Options
5 Camera Options
6 Function Programming
ESC to Exit
DIAGNOSTIC OPTIONS
1 Coordinates....................................OFF
2 Error Table .....................................OFF
3 Clear the Memory
4 Clear the Error Table
5 Display Error Tbl. Codes
6 Restore Default Settings
7 Reset Scan and Camera
8 Upload new firmware to HD6
ESC to Exit
Pan = xxx.x
Tilt=xxx.x
900.0679
22-June-2006