Restore Default Settings; Reset Scan And Camera; Upload New Firmware To Hd6 - Honeywell HD6 Series User Manual

5.4 DIAGNOSTIC OPTIONS, CONTINUED

5.4.6 Restore Default Settings

Select 6 to restore all default settings for
displays, alarms, camera settings, and
diagnostic settings to the factory default
values. Select Y to restore all defaults or N to
cancel and return to the Diagnostic Options
menu.
To send the Yes or No command from the
HJZTP controller, press the camera and
preset keys to scroll through the available
characters on the LCD display. When Y or N is flashing on the controller LCD, press the
Aux key. If Y is selected, confirmation of restored default settings is displayed.

5.4.7 Reset Scan and Camera

Select 7 to reset the scan and camera. This
resets the unit the same as if power had been
removed.
This can also be used to cause the HD6 to
find home.

5.4.8 Upload New Firmware to HD6

This option is for future use.
Rev. 1.02
THIS WILL RESTORE ALL USER DEFINED
SETTINGS TO THEIR DEFAULT
SURE THAT YOU WANT TO DO THIS? –
1 Coordinates....................................OFF
2 Error Table .....................................OFF
3 Clear the Memory
4 Clear the Error Table
5 Display Error Tbl. Codes
6 Restore Default Settings
7 Reset Scan and Camera
8 Upload new firmware to HD6
ESC to Exit
1 Coordinates....................................OFF
2 Error Table .....................................OFF
3 Clear the Memory
4 Clear the Error Table
5 Display Error Tbl. Codes
6 Restore Default Settings
7 Reset Scan and Camera
8 Upload new firmware to HD6
40
**** CAUTION****
VALUES. ARE YOU
Y/N -
DIAGNOSTIC OPTIONS
DIAGNOSTIC OPTIONS
ESC to Exit
900.0679
22-June-2006