Ptz Tour Operation - Honeywell HD6 Series User Manual

11.6 PROGRAMMING PTZ TOURS, CONTINUED
3. Wait for the countdown to reach 0 or send a PreShot 24 command to end the
programming mode. The message "PTZ Tour Complete" is displayed.
The scan stores the PTZ commands in the order you entered them between the time
you started the programming mode until you entered the PreShot 24 command.

11.7 PTZ TOUR OPERATION

PreShot commands 11, 12, and 13 are reserved for running PTZ tours 1, 2, and 3,
respectively. The scan, where the PTZ tour is stored, must be the control camera on the
system controller. The scan continues to run the PTZ tour from beginning to end
1. Enter a PreShot 11 command on the system controller to run PTZ tour 1.
(Enter a PreShot 12 command to run PTZ tour 2 or PreShot 13 command to run PTZ
tour 3.)
2. Stop the PTZ tour by manually controlling the scan or by sending the scan a
PreShot or VectorScan command.
Rev. 1.02 110 900.0679
22-June-2006