Program Alarms - Honeywell HD6 Series User Manual

5.3 CONTROL OPTIONS, CONTINUED
To perform this function:
1. Position the camera lens so it is not vertical.
2. Using the controller, tilt the camera down until the camera lens is vertical (pointing at
the floor) and continue tilting down with the controller.
3. The pan and tilt unit pans the camera 180° and then begins to tilt up.
It continues to tilt up as long as the controller remains in the "down" position.
When the Scan unit reaches its tilt up limit, the Scan returns to normal operation.
If the controller is returned to its neutral position before the Scan reaches its tilt up
limit, the Scan returns to normal operation.

5.3.3 Program Alarms

The HD6 has four alarm inputs for normally
open dry contacts. When a contact closes,
an alarm occurs. Alarms can be enabled or
disabled and the scan can be programmed
to go to a PreShot, start a VectorScan, or
start a PTZ tour when an alarm occurs.
Note: If an alarm is disabled, the HD6 does not respond to a change of state in the
alarm contact. The HD6 does not perform the programmed PreShot, VectorScan,
or PTZ. If a PreShot, VectorScan, or PTZ Tour is not programmed for an alarm,
the HD6 does not respond to a change of state in the contact.
To program alarms, select 3 from the Control
Options Menu.
The Program Alarms screen displays.
To enter a P, V, or T in the FUN field or a Yes
(Y) or No (N) in the ENA field when using an
HJZTP Controller,
a. Position the cursor on the FUN or ENA
field. Use the F1 ( ) F2 ( ), F3 ( ) or F4 ( ) keys to move the cursor between
fields.
b. Press the camera and preset keys to scroll through the available characters on the
controller's LCD. When the desired character is flashing on the LCD, press the aux
key.
Rev. 1.02
1 PASS ............................................... ON
2 Auto-Pivot........................................ ON
3 Program Alarms
4 Set Pan and Tilt Options
5 Set Default Function
6 Auto Focus ..........................................Z
7 VectorScan Auto Focus.................OFF
ESC to Exit
1
2
3
4
Press 'Enter' when done.
30
CONTROL OPTIONS
Program Alarms
FUN NUM ENA
_ __ _
_ __ _
_ __ _
_ __ _
PVT Y-N
900.0679
22-June-2006