Programming Preshots; Programming Preshots (Views) With Titles - Honeywell HD6 Series User Manual

7.2

PROGRAMMING PRESHOTS

A PreShot is a predefined scan and lens position (including the pan, tilt, zoom, and
focus settings, and, in some modes, iris settings).
• A PreShot can be saved with a number and title.
• The operator uses the PreShot number to send the scan unit to the PreShot.
• The PreShot title can be enabled or disabled.
The location of the PreShot title on the monitor display is programmable.
•
• If the camera ID is enabled, the letter A for automatic operation appears next to the
camera number display on the monitor whenever the scan has been sent to a
PreShot.
A total of 98 (00-97) PreShot positions are programmable per unit with the PreShots
stored on the receiver board. If an 843216-1011, 843216-1013 , 843216-0984, or
843216-0985 camera is installed, PreShot 99 is reserved for toggling the NightShot
mode on and off. PreShot 98 is reserved for the scan and camera reset function.

7.2.1 Programming PreShots (Views) with Titles

The following is an example of the programming procedure using an HJZTP controller.
Refer to your specific controller manual for programming PreShots (Views).
1. Adjust the pan, tilt, zoom, and focus of the unit until the desired scene is displayed
on the monitor.
2. Press and hold lock and press F6 (menu).
3. Move the joystick right until PRES is flashing on the LCD and then press the aux
key.
4. Move the joystick until PROGRAM is flashing and then press the aux key. The
Preshot programming prompts are displayed on the monitor.
5. Enter the PreShot # (0-99).
6. Press Enter (F5).
7. Enter the PreShot title.
a. Press the camera and preset keys to scroll through all available characters.
b. Continue step a. until the desired title is displayed on the monitor.
c. Press Enter (F5).
Rev. 1.02
When the desired character is flashing on the LCD, press the aux key.
84 900.0679
22-June-2006