Creating A Mlp Bundle Interface - Cisco 10000 Series Configuration Manual

Chapter 16 Fragmenting and Interleaving Real-Time and Nonreal-Time Packets
To configure MLP-based fragmentation and interleaving, perform the following configuration tasks:
•
•
•
•
•
•

Creating a MLP Bundle Interface

To create a MLP bundle interface, enter the following commands beginning in global configuration
mode:
Command
Step 1
Router(config)# interface multilink
multilink-bundle-number
Step 2
Router(config-if)# ip address address mask
OL-7433-09
Creating a MLP Bundle Interface, page 16-25
Enabling MLP on a Virtual Template Interface, page 16-27
Configuring a Shaping Policy for MLP Over Frame Relay-Based LFI, page 16-29
Configuring a Shaping Policy for MLP Over Frame Relay-Based LFI, page 16-29
Adding an ATM Member Link to a MLP Bundle, page 16-30
Adding a Frame Relay Member Link to a MLP Bundle, page 16-33
Multilink PPP-Based Link Fragmentation and Interleaving
Purpose
Creates a multilink bundle. Enters interface configuration
mode to configure the bundle.
multilink-bundle-number is a nonzero number that identifies
the multilink bundle. For Cisco IOS Release 12.2(28)SB and
later releases, valid values are:
MLP over Serial-based LFI
•
1 to 9999 (Cisco IOS Release 12.2(28)SB and later
–
releases)
1 to 9999 and 65,536 to 2,147,483,647 (Cisco IOS
–
Release 12.2(31)SB2 and later releases)
Single-VC MLP over ATM-based LFI
•
10,000 and higher
–
Multi-VC MLP over ATM-based LFI
•
1 to 9999 (Cisco IOS Release 12.2(28)SB and later
–
releases)
1 to 9999 and 65,536 to 2,147,483,647 (Cisco IOS
–
Release 12.2(31)SB2 and later releases)
MLP over Frame Relay-based LFI
•
10,000 and higher
–
For releases prior to Cisco IOS Release 12.2(28)SB,
Note
valid values are from 1 to 2,147,483,647.
Specifies the IP address and subnet mask assigned to the
interface.
address is the IP address.
mask is the subnet mask for the associated IP address.
Cisco 10000 Series Router Quality of Service Configuration Guide
16-25