Verification Example For Mlp Over Serial-Based Lfi - Cisco 10000 Series Configuration Manual

Chapter 16 Fragmenting and Interleaving Real-Time and Nonreal-Time Packets
Command
Router# show interfaces virtual-access number
[configuration]
Router# show ppp multilink [bundle-interface]
Router# show running-config

Verification Example for MLP Over Serial-Based LFI

Example 16-23
displays information about the MLP over serial-based LFI configuration provided in
page
Example 16-23 show ppp multilink interface Command Sample Output
Router# show ppp multilink interface Multilink2
Multilink2, bundle name is group2
Endpoint discriminator is group2
Bundle up for 02:31:57, 1/255 load
Receive buffer limit 36000 bytes, frag timeout 1000 ms
Bundle is Distributed
C10K Multilink PPP info
Member links: 3 active, 0 inactive (max 10, min not set)
Multilink2
Service-policy output: policy_MLPLFI
OL-7433-09
shows sample output from the show ppp multilink interface command. This example
16-59.
0/0 fragments/bytes in reassembly list
0 lost fragments, 0 reordered
0/0 discarded fragments/bytes, 0 lost received
0x0 received sequence, 0x1 sent sequence
Bundle transmit info
send_seq_num 0x1
Bundle reassembly info
expected_seq_num:
Se8/0/0.2/7:0, since 02:31:57, 384 weight, 378 frag size
Se8/0/0.2/9:0, since 00:03:46, 384 weight, 378 frag size
Se8/0/0.2/8:0, since 00:03:06, 384 weight, 378 frag size HQF2_R2#
Class-map: prec_5 (match-all)
Verifying and Monitoring Link Fragmentation and Interleaving
Purpose
Displays status, traffic data, and configuration information about
the virtual access interface you specify.
Note This command currently displays statistics for system
traffic only. Statistics for bundle traffic do not display.
For information about bundle traffic, see the show
interfaces or show ppp multilink command.
number is the number of the virtual access interface.
(Optional) configuration restricts output to configuration
information.
Displays bundle information for all of the MLP bundles and their
PPP links configured on the router.
If you specify bundle-interface, the command displays
information for only that specific bundle.
(Optional) bundle-interface specifies the multilink interface (for
example, Multilink 5).
Displays information about the current router configuration,
including information about each interface configuration.
0x000000
Cisco 10000 Series Router Quality of Service Configuration Guide
Example 16-15 on
16-67