Creating An Mlp Bundle Interface - Cisco 10000-2P2-2DC Software Configuration Manual

Configuring MLP Bundles and Member Links
Table 22-8
Type
MLP over Serial
Single-VC MLP over ATM
Multi-VC MLP over ATM
1. A service policy is required only when configuring MLP-based link fragmentation and interleaving (LFI) for Single-VC or
To configure MLP bundles and member links, perform the following configuration tasks:
•
•
•
•
The following configuration tasks are optional:
•
•
•

Creating an MLP Bundle Interface

To create an MLP bundle interface, enter the following commands beginning in global configuration
mode:
Cisco 10000 Series Router Software Configuration Guide
22-28
Requirements for Configuring MLP
Multi-VC MLP over ATM. For MLP-based LFI, a service policy with a priority queue defined must be attached to the
multilink interface. The VC does not require a service policy.
Creating an MLP Bundle Interface, page 22-28
Enabling MLP on a Virtual Template, page 22-30
Adding a Serial Member Link to an MLP Bundle, page 22-31
Adding an ATM Member Link to an MLP Bundle, page 22-32
Moving a Member Link to a Different MLP Bundle, page 22-35
Removing a Member Link from an MLP Bundle, page 22-36
Changing the Default Endpoint Discriminator, page 22-37
Chapter 22 Configuring Multilink Point-to-Point Protocol Connections
MLP Bundle Member Links
Required Required
Required Required
Required Required
Virtual Template Service Policy
Not required Not required
Required Required
Required Required
1
1
OL-2226-23