Verifying The Configuration Of Hierarchical Policies - Cisco 10000 Series Configuration Manual

Chapter 13 Defining QoS for Multiple Policy Levels
!
policy-map vlan10_policy
!
policy-map vlan20_policy
!
!
interface GigabitEthernet 1/0/0.10
!
interface GigabitEthernet 1/0/0.20
For information on bandwidth-remaining ratios, see
Ratio" section on page 5-14
Release 12.2(31)SB2 feature module.

Verifying the Configuration of Hierarchical Policies

To verify hierarchical policies, enter any of the following commands in privileged EXEC mode:
Command
Router# show class-map
Router# show policy-map
Router# show policy-map interface
OL-7433-09
class precedence_2
shape average 500000
bandwidth remaining ratio 60 <---- Class-level ratio
class class-default
shape average 1000000
bandwidth remaining ratio 10 <---- Subinterface-level ratio
service-policy child-policy
class class-default
shape average 1000000
bandwidth remaining ratio 100 <---- Subinterface-level ratio
service-policy child_policy
encapsulation dot1q 10
service-policy output vlan10_policy
encapsulation dot1q 20
service-policy output vlan20_policy
or the Distribution of Remaining Bandwidth Using Ratio,
Verifying the Configuration of Hierarchical Policies
"Distribution of Remaining Bandwidth Using
Purpose
Displays the configuration of all class maps configured on the
router.
Displays the configuration of all policy maps configured on the
router.
Displays the configuration of all classes configured for all policy
maps attached to all interfaces.
Cisco 10000 Series Router Quality of Service Configuration Guide
13-27