Mpls Experimental Command; Oam-Bundle Command; Precedence Command (Frame Relay Vc-Bundle-Member); Protect Command (Frame Relay Vc-Bundle-Member) - Cisco 10000 Series Configuration Manual
Quality of service configuration guide
Hide thumbs
Also See for 10000 Series:
- Configuration manual (370 pages) ,
- Troubleshooting manual (70 pages) ,
- Installation manual (14 pages)
Table of Contents
Advertisement
QoS Features, Commands, and Changes
mpls experimental Command
Cisco IOS Release: Release 12.0(26)S
Description: The mpls experimental command was introduced on the PRE1 to configure MPLS
experimental (EXP) levels for a VC class or for a PVC member of a bundle. The VC class is applied to
the PVC bundle and thus applied to all PVC members of the bundle.
oam-bundle Command
Cisco IOS Release: Release 12.0(26)S
Description: The oam-bundle command was introduced on the PRE1 to enable end-to-end F5
Operation, Administration, and Maintenance (OAM) loopback cell generation and OAM management
for all permanent virtual circuit (PVC) members of a bundle or a VC class that can be applied to a PVC
bundle.
precedence Command
Cisco IOS Release: Release 12.0(26)S
Description: The precedence command was introduced on the PRE1 to configure precedence levels for
a virtual circuit (VC) class, VC, or permanent virtual circuit (PVC) member of a bundle. The VC class
is assigned to a PVC bundle and thus applied to all PVC members of that bundle.
precedence Command (Frame Relay VC-bundle-member)
Cisco IOS Release: Release 12.0(26)S
Description: The precedence command was introduced on the PRE1 to configure the precedence levels
for a Frame Relay permanent virtual circuit (PVC) bundle member.
protect Command
Cisco IOS Release: Release 12.0(26)S
Description: The protect command was introduced on the PRE1 to configure a virtual circuit (VC) class
with protected group or protected VC status for application to a PVC bundle member and to configure a
specific VC or permanent virtual circuit (PVC) as part of a protected group of the bundle or to configure
it as an individually protected VC or PVC bundle member.
protect Command (Frame Relay VC-bundle-member)
Cisco IOS Release: Release 12.0(26)S
Description: The protect command was introduced on the PRE1 to configure a Frame Relay protected
permanent virtual circuit (PVC) bundle member with protected group or protected PVC status.
Cisco 10000 Series Router Quality of Service Configuration Guide
1-52
Chapter 1
Quality of Service Overview
OL-7433-09
Advertisement
Chapters
Table of Contents
