Attaching Qos Service Policies To An Atm Interface - Cisco 10000 Series Configuration Manual

Attaching ATM QoS Service Policies

Attaching QoS Service Policies to an ATM Interface

To attach a QoS service policy to an ATM interface, enter the following commands beginning in interface
configuration mode:
Command
Step 1
Router(config)# interface atm
slot/module/port
Step 2
Router(config-if)# service-policy {input
| output} policy-map-name
Configuration Example for Attaching QoS Service Policies to an ATM Interface
Example 4-1
ATM interface 1/0/0. The router applies the service policy to all of the PVCs configured on the interface.
Example 4-1
Router(config)# interface atm 1/0/0
Router(config-if)# service-policy input myQoS
Cisco 10000 Series Router Quality of Service Configuration Guide
4-6
Purpose
Specifies the interface to which you want to attach the QoS
service policy and enters interface configuration mode.
Attaches the service policy you specify to the interface.
input indicates to apply the service policy to inbound traffic on
the interface.
output indicates to apply the service policy to outbound traffic on
the interface.
Note
policy-map-name is the name of the policy map you want to attach
to the subinterface.
Note
shows how to attach the QoS service policy named myQoS to inbound traffic arriving at
Attaching a QoS Policy to an ATM Interface
For QoS policies containing the bandwidth, priority,
random-detect, queue-limit, and shape commands, you
must specify the output keyword. If you use these
commands with the input keyword, the router ignores the
commands.
The router applies the service policy to the ATM interface
and to all PVCs configured on the interface that do not
have their own QoS policy applied.
Chapter 4 Attaching Service Policies
OL-7433-09