Pvc-Bundle Command - Cisco 10000 Series Configuration Manual

Chapter 19 Configuring Quality of Service for PVC Bundles
protect Command History
Cisco IOS Release
Release 12.0(26)S
Defaults
The VC or PVC neither belongs to the protected group nor is it an individually protected VC or PVC.
Configuration Modes
VC-class configuration (for a VC class)
Bundle-vc configuration (for ATM VC bundle members)
Usage Guidelines for the protect Command
Use the protect command in vc-class configuration mode to configure a VC class to contain protected
group or individual protected VC status. When the class is applied to the VC bundle member, that VC is
characterized by the protected status. You can also apply this command directly to a VC in bundle-vc
configuration mode.
When a protected VC goes down, it takes the bundle down. When all members of a protected group go
down, the bundle goes down.
To use the protect command in vc-class configuration mode, first enter the vc-class atm global
configuration command.
The protect command has no effect if the VC class that contains the command is attached to a standalone
VC, that is, if the VC is not a bundle member.
To use the protect command in bundle-vc configuration mode, first enter the bundle command to enact
bundle configuration mode for the bundle containing the VC member to be configured. Then enter the
pvc-bundle configuration command to add the VC to the bundle as a member of it.
VCs in a VC bundle are subject to the following configuration inheritance guidelines (listed in order of
next highest precedence):
•
•
•

pvc-bundle Command

To add a permanent virtual circuit (PVC) to a bundle as a member of the bundle and enter bundle-vc
configuration mode in order to configure that PVC bundle member, use the pvc-bundle command in
bundle configuration mode. To remove the VC from the bundle, use the no form of the command.
pvc-bundle pvc-name [vpi/] [vci]
no pvc-bundle pvc-name [vpi/] [vci]
OL-7433-09
Description
This command was introduced on the PRE1.
VC configuration in bundle-vc mode
Bundle configuration in bundle mode (with effect of assigned vc-class configuration)
Subinterface configuration in subinterface mode
Cisco 10000 Series Router Quality of Service Configuration Guide
ATM PVC Selection
19-13