Cisco 10000 Series Configuration Manual page 605

Chapter 17 Configuring Dynamic Subscriber Services
Example 17-17
QoS updates using RADIUS. When the router establishes a PPPoEoA session, the router downloads or
pulls the service policy names test_vc and dyn_out from the RADIUS server to the VC. The policy maps
downloaded from the RADIUS server have higher precedence than the policy maps (voice and outname)
configured directly on the PVC. The sample output from the show policy-map interface command
indicates that the RADIUS policies have been downloaded.
Example 17-17 Pulling QoS Parameters from RADIUS to Existing Policies
Router# show policy-map
!
interface ATM4/0/0.3 multipoint
no atm enable-ilmi-trap
pvc 4/103
dbs enable
encapsulation aal5autoppp Virtual-Template1
service-policy input voice
service-policy output outname
!
end
Router# show policy-map interface atm 4/0/0.3
ATM4/0/0.3: PVC 4/103 -
Service-policy input: test_vc
Class-map: class-default (match-any)
Service-policy output: dyn_out
Class-map: class-default (match-any)
Router# show pppoe session
PPPoE Session Information
Unique ID
OL-7433-09
shows a sample configuration that includes the dbs enable command to enable dynamic
0 packets, 0 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: any
0 packets, 0 bytes
5 minute rate 0 bps
5 packets, 370 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: any
5 packets, 370 bytes
5 minute rate 0 bps
PPPoE RemMAC
SID LocMAC VA-st
2 2 0010.1436.bc70
0010.1436.b070
Applying QoS Parameters Dynamically to Sessions
Port VT VA State
ATM4/0.31 Vi3.1 PTA
VC:4/103
Cisco 10000 Series Router Quality of Service Configuration Guide
UP
17-31