Cisco 10000 Series Configuration Manual page 623

Chapter 17 Configuring Dynamic Subscriber Services
Configuration Example for Configuring a Per Session Shaping and Queuing on LNS Policy
Example 17-27
example, the router uses 20 overhead bytes and ATM cell tax in calculating ATM overhead. The child
and parent policies contain the required matching offset values. The parent policy is attached to virtual
template 1.
Example 17-27 Configuring Per Session Shaping and Queuing on LNS Policy on the Router
policy-map child
policy-map parent
interface virtual-template 1
Verifying Per Session Shaping and Queuing on LNS Policies
To display the configuration of per session shaping and queuing on LNS policies, enter the following
commands in privileged EXEC mode:
Command
Router# show policy-map [policy-map]
Router# show running-config
OL-7433-09
shows how to configure a per session shaping and queuing on LNS policy. In this
class class1
bandwidth 500 account user-defined 20 atm
class class2
shape average 30000 account user-defined 20 atm
class class-default
shape average 30000 account user-defined 20 atm
service-policy child
service-policy output parent
Shaping and Queuing Per-Session Traffic on LNS
Purpose
Displays the configuration of all classes for a specified service
policy map or all classes for all existing policy maps.
policy-map specifies the name of the policy map.
Displays the running configuration on the router. The output
shows the configuration of the policy maps.
Cisco 10000 Series Router Quality of Service Configuration Guide
17-49