Attaching Layer 2 Access Concentrator Qos Service Policies; Feature History For Lac Qos; Lac Qos Inheritance - Cisco 10000 Series Configuration Manual

Quality of service configuration guide
Hide thumbs Also See for 10000 Series:
Table of Contents

Advertisement

Attaching Layer 2 Access Concentrator QoS Service Policies

Attaching Layer 2 Access Concentrator QoS Service Policies
You can attach a QoS service policy to an ATM VC on the Layer 2 access concentrator (LAC) using the
service-policy command.
This section describes the following topics:

Feature History for LAC QoS

Cisco IOS Release
12.3(7)XI3
12.2(28)SB

LAC QoS Inheritance

The following describes how LAC traffic inherits QoS policies:
When a service policy is attached to an individual ATM PVC, sessions that use that PVC inherit the
service policy applied to the PVC or the inherited policy of the PVC. If a session inherits a policy, the
show policy interface virtual access command does not display the state of the inherited policy. You
can display the state of the policy only on the interface where you configured the policy. If you attach a
service policy only to:
Cisco 10000 Series Router Quality of Service Configuration Guide
4-30
Feature History for LAC QoS, page 4-30
LAC QoS Inheritance, page 4-30
Restrictions and Limitations for Attaching LAC QoS, page 4-31
Attaching QoS Policies to LAC ATM Virtual Circuits, page 4-31
Description
The QoS: Broadband Aggregation Enhancements - Phase 1
feature (also known as LAC QoS) was introduced on the
router to support LAC QoS policies on an ATM virtual
circuit.
LAC QoS was integrated in Cisco IOS
Release 12.2(28)SB.
If you attach a service policy only to the physical ATM interface, the aggregate of all unshaped UBR
PVCs is subject to the physical interface's service policy. The router treats shaped UBR PVCs like
variable bit rate (VBR) and constant bit rate (CBR) PVCs.
If you attach a service policy only to individual ATM PVCs and not to the physical ATM interface,
only the individual PVC is subject to its attached service policy.
If you attach service policies to both the physical ATM interface and individual ATM PVCs, the
aggregate of all UBR PVCs without an attached service policy is subject to the physical interface's
service policy. All PVCs with an attached service policy are individually subject to their attached
service policies.
The physical Ethernet interface, the aggregate of all of the VLAN subinterfaces is subject to the
physical interface's service policy.
Individual VLAN subinterfaces, and not to the physical Ethernet interface, only the individual
VLAN subinterfaces are subject to the attached service policies.
Chapter 4
Attaching Service Policies
Required PRE
PRE2
PRE2
OL-7433-09

Advertisement

Table of Contents
loading

Table of Contents