Restrictions And Limitations For Frame Relay Pvc Selection; Configuring Frame Relay Bundles - Cisco 10000 Series Configuration Manual

Chapter 19 Configuring Quality of Service for PVC Bundles

Restrictions and Limitations for Frame Relay PVC Selection

PVCs
•
•
•
•
•
VC Selection
•
•
•
Packet Forwarding
•

Configuring Frame Relay Bundles

To configure Frame Relay bundles, perform the following configuration tasks:
•
•
OL-7433-09
In Cisco IOS Release 12.0(26)S, the Frame Relay implementation of VC bundles is restricted to
PVCs.
You can configure a maximum of eight PVCs in a PVC bundle.
A PVC can be a member of one and only one PVC bundle.
A PVC that is a bundle member cannot be used in any other capacity. For example, you cannot
configure a PVC bundle member in a map statement.
The Cisco 10000 router does not support variable bit rate-real-time (VBR-rt) for PVCs.
A PVC bundle does not come up until you configure all of the precedence or DSCP levels in the
bundle.
You can map one or multiple precedence or DSCP levels to a single PVC; however, you cannot map
multiple PVCs to one precedence or DSCP level.
The Cisco 10000 router does not support the auto-mapping of PVCs.
The Cisco 10000 router does not support fast switching of IP packets.
Creating a Frame Relay PVC Bundle, page 19-42
Adding a PVC to a Frame Relay PVC Bundle, page 19-43
Cisco 10000 Series Router Quality of Service Configuration Guide
Frame Relay PVC Selection
19-41