Cisco 10000 Series Configuration Manual page 478

Configuring Oversubscription
Command
Step 4
Router(config-pmap-c)# police [cir] percent
percent bc normal-burst-in-msec {pir pir}
be excess-burst-in-msec [conform-action action
[exceed-action action [violate-action action]]]
Step 5
Router(config-pmap-c)# exit
Step 6
Router(config)# policy-map policy-map-name
Cisco 10000 Series Router Quality of Service Configuration Guide
15-18
Chapter 15 Oversubscribing Physical and Virtual Links
Purpose
(Optional) Configures traffic policing on the basis of a
percentage of bandwidth available on an interface.
(Optional) cir is the committed information rate (CIR) and
indicates an average rate at which the policer meters traffic.
percent percent indicates to use the percentage of available
bandwidth specified in percent to calculate the CIR.
bc normal-burst-in-msec specifies the normal or committed
burst size (CBS) that the first token bucket uses for policing
traffic. Specify the normal-burst-in-msec value in
milliseconds (ms). Valid values are from 1 to 2000. The
default value is the greater of 2 ms worth of bytes at the
police rate or the network minimum transmission unit
(MTU).
be excess-burst-in-msec specifies the excess burst size
(EBS) that the second token bucket uses for policing traffic.
Specify the excess-burst-in-msec value in milliseconds
(ms). Valid values are from 1 to 2000. The default value is
zero (0). You must specify normal-burst-in msec before you
specify excess-burst-in-msec.
Burst in milliseconds is based on the policing
Note
committed information rate (CIR).
conform-action action is the action to take on packets that
conform to the rate limit. The default action is transmit. You
must specify burst-excess before you specify the
conform-action.
exceed-action action is the action to take on packets that
exceed the rate limit, but not the PIR. The default action is
drop. You must specify the conform-action before you
specify the exceed-action.
(Optional) violate-action action is the action to take on
packets that continuously exceed the PIR rate limit. The
default action is the same as the exceed-action. You must
specify the exceed-action before you specify the
violate-action.
See Table 6-1 on page 6-3
you can specify.
Repeat Step 2 through Step 4 to configure additional
Note
traffic classes. For information about additional
actions you can specify, see the
Actions" section on page
Exits policy-map class configuration mode.
Creates or modifies the parent policy map. Enters
policy-map configuration mode.
policy-map-name is the name of the policy map. The name
can be a maximum of 40 alphanumeric characters.
for a description of each action
"Types of QoS
3-4.
OL-7433-09