Cisco 10000 Series Configuration Manual page 633

Chapter 17 Configuring Dynamic Subscriber Services
Command
Step 5
Router(config-subif) pvc [name] vpi/vci
Step 6
Router(config-atm-vc)# protocol pppoe
group group-name
Step 7
Router(config-atm-vc)# exit
Step 8
Router(config-subif)# exit
The following example shows how to associate a virtual template interface with an ATM interface and
apply the policies in the virtual template to the sessions on the interface. In the example, the service
policy named Parent is applied to the Virtual-Template 8, which is associated with the bba-group named
pppoeoa-group. The bba-group is applied to PVC 101/210 on ATM subinterface 4/0/1.10.
bba-group pppoe pppoeoa-group
interface ATM4/0/1.10 point-to-point
!
interface Virtual-Template8
OL-7433-09
Virtual-Template 8
pvc 101/210
vbr-nrt 4000 2000 50
no dbs enable
encapsulation aal5snap
protocol pppoe group pppoeoa-group
ip unnumbered Loopback5555
Purpose
Creates or modifies an ATM permanent virtual circuit (PVC).
Enters ATM virtual circuit configuration mode.
(Optional) name identifies the PVC and can contain up to 15
characters.
vpi/ specifies the ATM network virtual path identifier (VPI) for
this PVC. You must specify the slash. Valid values are from 0 to
255. The router treats a value that is outside the range of valid
values as the connection ID. The default value is 0.
The arguments vpi and vci cannot both be set to 0; if one
Note
is 0, the other cannot be 0.
vci specifies the ATM network virtual channel identifier (VCI) for
this PVC. Valid values are from 0 to 1 less than the maximum
value set for this interface by the atm vc-per-vp command. A
value that is out of range causes an "unrecognized command"
error message.
The VCI value has local significance only and, therefore,
Note
is unique only on a single link, not throughout the ATM
network. Typically, lower values from 0 to 31 are reserved
for specific traffic (for example, F4 OAM, SVC signaling,
ILMI, and so on) and should not be used.
Enables PPP over Ethernet (PPPoE) sessions to be established on
permanent virtual circuits (PVCs).
group specifies a PPPoE profile (bba-group) to be used by PPPoE
sessions on the interface.
group-name is the name of the PPPoE profile (bba-group) to be
used by PPPoE sessions on the interface.
Note The group group-name points to the bba-group to be used
for applying a virtual template interface with QoS policies
to sessions.
Exits ATM virtual circuit configuration mode.
Exits subinterface configuration mode.
Cisco 10000 Series Router Quality of Service Configuration Guide
Queuing PPP Sessions on ATM VCs
17-59