Cisco 10000 Series Configuration Manual page 451

Chapter 14 Simultaneous Policy Maps
Command
Step 1
Router(config)# interface atm number
[point-to-point | multipoint]
Step 2
Router(config-subif)# range pvc
start-vpi/end-vpi start-vci/end-vci
Step 3
Router(config-subif-atm-vc)# vbr-nrt
output-pcr output-scr output-mbs
Step 4
Router(config-subif-atm-vc)# encapsulation
aal5snap
Step 5
Router(config-subif-atm-vc)# protocol
pppoe
Configuration Example for Attaching a Policy to an ATM VC with PPPoE Sessions
The following example shows how to attach a simultaneous policy map to an ATM VC over which
PPPoE sessions traverse the network. The policy map named pppoe_sess_output_policy is attached to
Virtual-Template1, which is applied to the BBA group named VRF_1. The BBA group is attached to the
PVC range 81/801 to 81/810 on subinterface ATM 2/0/0.81801.
interface ATM2/0/0.81801 multipoint
!
bba-group pppoe VRF_1
OL-7433-09
range pvc 81/801 81/810
vbr-nrt 2000 2000 1
encapsulation aal5snap
protocol pppoe group VRF_1
Purpose
Creates or modifies a subinterface. Enters subinterface
configuration mode.
number is the slot, module, port, subinterface number of the
interface (for example, 4/0/1.10).
point-to-point indicates that the subinterface connects directly
to one endpoint.
multipoint indicates that the subinterface connects to multiple
endpoints.
Defines a range of ATM permanent virtual circuits (PVCs).
(Optional) start-vpi/ is the beginning value for a range of virtual
path identifiers (VPIs). In the absence of the "/" and a VPI value,
the VPI value defaults to 0. Valid values are from 0 to 255.
(Optional) end-vpi is the end value for a range of virtual path
identifiers (VPIs). In the absence of an end-VPI value, the
end-VPI value defaults to the start-VPI value. Valid values are
from 0 to 255.
start-vci/ is the beginning value for a range of virtual channel
identifiers (VCIs). Valid values are from 32 to 65535. You must
specify the slash mark (/).
end-vci is the end value for a range of virtual channel identifiers
(VCIs). Valid values are from 32 to 65535.
Configures the variable bit rate-nonreal time (VBR-NRT)
quality of service (QoS).
output-pcr is the output peak cell rate (PCR), in kbps.
output-scr is the output sustained cell rate (SCR), in kbps.
output-mbs is the output maximum burst cell size, expressed in
number of cells.
Configures the ATM adaptation layer (AAL) and encapsulation
type for the PVC range.
Specifies the tunneling protocol that a virtual private dialup
network (VPDN) subgroup is to use, in this case PPPoE.
Cisco 10000 Series Router Quality of Service Configuration Guide
Configuring Simultaneous Policy Maps
14-13