Creating A Map Class - Cisco 10000 Series Configuration Manual

Configuring Frame Relay QoS Using Frame Relay
Legacy Commands
This appendix describes how to configure Frame Relay QoS using Frame Relay legacy commands using
the following procedures:
1.
2.
3.
4.
5.
6.
7.

Creating a Map Class

To create a Frame Relay map class, enter the following command in global configuration mode:
Command
Router(config)# map-class frame-relay
class-map-name
Example A-1
Example A-1
Router(config)# map-class frame-relay camry
Router(config-map-class)#
OL-7433-09
Creating a Map Class, page A-1
Enabling Weighted Fair Queuing on the Interface, page A-2
Specifying a DLCI Queue Weight, page A-2
Specifying Tail Drop, page A-3
Enabling RED Drop, page A-3
Configuring Frame Relay IP RTP Priority, page A-4
Configuring Frame Relay Traffic Shaping, page A-5
creates a map class named camry.
Configuring a Frame Relay Map Class
A P P E N D I X
Purpose
Creates a Frame Relay map class.
class-map-name is the name of the class map.
Cisco 10000 Series Router Quality of Service Configuration Guide
A
A-1