Cisco 10000 Series Configuration Manual page 448

Configuring Simultaneous Policy Maps
Command
Step 1
Router(config)# interface atm number
[point-to-point | multipoint]
Step 2
Router(config-subif)# range pvc
start-vpi/end-vpi start-vci/end-vci
Step 3
Router(config-subif-atm-vc)# vbr-nrt
output-pcr output-scr output-mbs
Step 4
Router(config-subif-atm-vc)# encapsulation
aal5mux ppp virtual-template number
Step 5
Router(config-atm-vc)# service-policy
output policy-map-name
Configuration Example of Attaching a Policy to an ATM VC with PPPoA Sessions
The following example shows how to attach a simultaneous policy map named pppoa_output_policy to
PVCs in the range of 42/101 to 42/110 on the multipoint ATM interface 3/0/0.42101:
interface ATM3/0/0.42101 multipoint
Cisco 10000 Series Router Quality of Service Configuration Guide
14-10
range pvc 42/101 42/110
vbr-nrt 2000 2000 1
Purpose
Creates or modifies a subinterface. Enters subinterface
configuration mode.
number is the slot, module, port, subinterface number of the
interface (for example, 4/0/1.10).
point-to-point indicates that the subinterface connects directly
to one endpoint.
multipoint indicates that the subinterface connects to multiple
endpoints.
Defines a range of ATM permanent virtual circuits (PVCs).
(Optional) start-vpi/ is the beginning value for a range of virtual
path identifiers (VPIs). In the absence of the "/" and a VPI value,
the VPI value defaults to 0. Valid values are from 0 to 255.
(Optional) end-vpi is the end value for a range of virtual path
identifiers (VPIs). In the absence of an end-VPI value, the
end-VPI value defaults to the start-VPI value. Valid values are
from 0 to 255.
start-vci/ is the beginning value for a range of virtual channel
identifiers (VCIs). Valid values are from 32 to 65535. You must
specify the slash mark (/).
end-vci is the end value for a range of virtual channel identifiers
(VCIs). Valid values are from 32 to 65535.
Configures the variable bit rate-nonreal time (VBR-NRT)
quality of service (QoS).
output-pcr is the output peak cell rate (PCR), in kbps.
output-scr is the output sustained cell rate (SCR), in kbps.
output-mbs is the output maximum burst cell size, expressed in
number of cells.
Configures the ATM adaptation layer (AAL) and encapsulation
type for the PVC range.
ppp configures the interface for PPP routing.
number is a number that identifies the virtual template.
Attaches the specified policy map to the specified PVC range in
the outbound direction.
policy-map-name is the name of a previously configured policy
map.
Chapter 14 Simultaneous Policy Maps
OL-7433-09