Applying Child Policies Under Priority Classes; Interfaces Supporting Hierarchical Policies - Cisco 10000 Series Configuration Manual

Quality of service configuration guide
Hide thumbs Also See for 10000 Series:
Table of Contents

Advertisement

Applying Child Policies Under Priority Classes

Applying Child Policies Under Priority Classes
The Cisco 10000 series router allows you to apply a child policy with non-queuing features under a
priority class in Cisco IOS Release 12.2(31)SB2 and later releases. In a three-level hierarchical policy,
the priority class to which you attach the child policy must be in the middle-level policy. In a two-level
hierarchical policy (nested policy), the priority class to which you attach the child policy is in the parent
policy.
For more information, see the Child Service Policy Allowed Under Priority Class feature module for
Cisco IOS Release 12.2(31)SB2.

Interfaces Supporting Hierarchical Policies

The following describes interface support for hierarchical policies using the service-policy command:
Interfaces Supporting Hierarchical Policies (Outbound Only)
The router only supports nested and three-level hierarchical policies on outbound interfaces.
Note
Interfaces Supporting Hierarchical Policies (Inbound only)
The router only supports hierarchical input policing policies on inbound interfaces.
Note
Interfaces Not Supporting Hierarchical Policies
Cisco 10000 Series Router Quality of Service Configuration Guide
13-12
Physical
ATM constant bit rate (CBR) PVCs and point-to-point subinterfaces
ATM variable bit rate (VBR) PVCs and point-to-point subinterfaces
ATM shaped (peak cell rate is specified) unspecified bit rate (UBR) PVCs and point-to-point
subinterfaces
Label-controlled ATM (LC-ATM) subinterfaces
Frame Relay PVCs, point-to-point subinterfaces, and map classes
Ethernet VLANs
Physical
ATM constant bit rate (CBR) PVCs and point-to-point subinterfaces
ATM variable bit rate (VBR) PVCs and point-to-point subinterfaces
Label-controlled (LC)-ATM subinterfaces
Frame Relay PVCs, point-to-point subinterfaces, and map classes
Ethernet VLANs
Multilink PPP and Multilink Frame Relay
ATM unshaped (no peak cell rate specified) UBR PVCs and point-to-point subinterfaces
IP tunnel
Virtual-access (See the
"VAI QoS Inheritance" section on page
Chapter 13
Defining QoS for Multiple Policy Levels
4-24.)
OL-7433-09

Advertisement

Table of Contents
loading

Table of Contents