Tone Configuration Parameters - Cisco ATA186-I1 Administrator's Manual

Tone Configuration Parameters

Tone Configuration Parameters
If you are running Cisco CallManager 3.3(3) with the Cisco IP Telephony Locale Installer, you should
configure call-progress tones using the Network Locale option on the Cisco CallManager configuration
page. For more information about using the Network Locale option, see the
Telephony Network Locale Option" section on page
If the desired network locale does not exist, you can configure call-progress tones using the Cisco ATA
parameters described in this section. For the Cisco ATA to use the Cisco ATA tone parameter values
described in this section, you must set bit 0 the Cisco ATA ConnectMode parameter to the value 1. For
more information on the ConnectMode parameter, see the
do not set this bit value to 1, the Cisco ATA will use the Cisco CallManager default tone settings for the
United States.
The Cisco ATA supports the following tone parameters:
•
•
•
•
•
•
•
The Cisco ATA supports two types of tone-parameter syntax—basic format and extended format. Basic
format is used in most countries; use the extended format only if the country in which the Cisco ATA is
used requires this format.
This section covers all the call-progress tones that the Cisco ATA supports, and contains the following
topics:
•
•
•
•
For detailed recommendations of tone-parameter values by country, see
Note
Cisco ATA Tone Parameter Values by Country."
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0)
5-26
DialTone
DialTone2
BusyTone
ReorderTone
RingBackTone
CallWaitTone
AlertTone
Tone Parameter Syntax—Basic Format, page 5-27
Tone Parameter Syntax—Extended Formats, page 5-28
Recommended Values, page 5-33
Specific Tone Parameter Information, page 5-33
Chapter 5
"Using the Cisco IP
4-5.
"ConnectMode" section on page
Appendix E, "Recommended
Parameters and Defaults
5-21. If you
OL-4652-01