Using The Cisco Bulk Administration Tool (Bat) - Cisco ATA186-I1 Administrator's Manual

Chapter 4 Adding the Cisco ATA to the Cisco CallManager
In the Phone Configuration screen, you must enter information in the following fields:
Step 7
•
•
•
Step 8 Click the Insert button (called the Update button in Cisco CallManager version 3.2).
The Cisco CallManager Administration application should inform you that the device has been added to
the database. You are also asked if you want to assign a directory number for the Phone 1 port at this
time.
Click OK.
Step 9 In the Directory Number field, assign a directory number to the Cisco ATA.
Step 10 From the Partition drop-down list, you can select a partition for the Cisco ATA or you can keep the
default value of None.
Step 11 Click the Insert button (called the Update button in Cisco CallManager version 3.2).
A popup window asks you if you want to return to the current-device page. Click OK.
Step 12 To add a second FXS port to Cisco CallManager, go back to Step 3 and proceed from there.
You need to fabricate a MAC address for the Phone 2 port by dropping the two left-most digits from the
Cisco ATA MAC address and add the digits 01 to the right-most portion of the MAC address.
Example
If the MAC address of the Cisco ATA is 00070EA26032, then the fabricated MAC address for the Phone
2 port would be 070EA2603201.
Note

Using the Cisco Bulk Administration Tool (BAT)

The Cisco Bulk Administration Tool (BAT) is a plug-in application for Cisco CallManager that enables
system administrators to perform batch operations, including registration, on large numbers of Cisco IP
Phones and Cisco ATAs.
Refer to the Bulk Administration Tool Guide for Cisco CallManager for instructions on using BAT to
add Cisco ATAs to the Cisco CallManager.
OL-4652-01
MAC Address —Enter the MAC address of the Cisco ATA.
Device Pool—Select either the Default value or a configured device pool from the drop-down list.
Phone Button Template—From the drop-down list, select Standard 7960 if you are using
Cisco CallManager version 3.0 or 3.1; select Standard ATA 186 if you are using
Cisco CallManager version 3.2
By default, both Cisco ATA FXS ports are enabled for Cisco CallManager registration. If you do
not want to add the Phone 2 FXS port to Cisco CallManager, you must change the Cisco ATA
EPID1orSID1 parameter value to 0 to disable the Phone 2 port. (To disable the Phone 1 port,
you must change the EPID0orSID0 parameter value to 0.)
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0)
Using the Cisco Bulk Administration Tool (BAT)
4-3