Cisco ATA186-I1 Administrator's Manual page 146

Using System Diagnostics
Example—Cisco ATA Configuration Update Message
<30>00:00:01 192.168.3.237 [03]:ATA Config Update OK
This message includes the following information:
Priority=30, which means that the facility value is 3 (system daemon) and the severity value is 6 (
•
informational messages). You can derive this information from RFC-3164.
• The time offset of the message is 00:00:01, which means that the most recent Cisco ATA reset was
one second earlier.
• The tag value is 03, which corresponds to Cisco ATA configuration-update messages. This is
derived from
This message shows indicates the status of the Cisco ATA configuration-file update.
•
Example—System Reboot Message
<31>00:00:00 192.168.3.220 [04]:Reboot from ata00012d010829(HWVersion1)
@192.168.3.220 (warmStart:0)
This message includes the following information:
Priority=31, which means that the facility value is 3 (system daemon) and the severity value is 7
•
(debug-level messages). You can derive this information from RFC-3164.
The time offset of the message is 0.
•
The tag value is 04, which corresponds to system-reboot messages. This is derived from
•
on page
This message includes the MAC address, hardware version and IP address of the Cisco ATA, and
•
the reason for the reboot.
Example—Cisco ATA Event Messages
<142>00:00:40 192.168.3.169 [09]:[0]OFFHOOK
<142>00:00:43 192.168.3.169 [09]:[0]ONHOOK
<142>00:01:35 192.168.3.169 [09]:[0]OFFHOOK
<142>00:01:50 192.168.3.169 [09]:[0]DTMF 2 , insum:830200
<142>00:01:50 192.168.3.169 [09]:[0]DTMF 2 , insum:854313
<142>00:01:50 192.168.3.169 [09]:[0]DTMF 1 , insum:868411
<142>00:01:50 192.168.3.169 [09]:[0]DTMF 2 , insum:861215
<142>00:01:50 192.168.3.169 [09]:[0]DTMF 0 , insum:858638
<142>00:01:51 192.168.3.169 [09]:[0]DTMF # , insum:845590
<142>00:01:51 192.168.3.169 [09]:[0]CLIP 22120
These messages include the following information:
Priority=142, which means that the facility value is 17 (local use 1) and the severity value is 6
•
(informational messages). You can derive this information from RFC-3164.
The time offset of the first message is 40 seconds.
•
The tag value is 09, which corresponds to Cisco ATA event messages. This is derived from
•
Table 5-7 on page
The ch (active line of the Cisco ATA) is line 0, which is the Phone 1 port of the Cisco ATA.
•
The messages include DTMF debugging (showing the key and the insum number), on/off hook,
•
Caller ID (CLIP/CLIR) and the callee number.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0)
8-8
Table 5-7 on page 5-39.
5-39.
5-39.
Chapter 8 Troubleshooting
Table 5-7
OL-4652-01