Additional Supported Signaling Protocols; Other Supported Protocols; Basic Services - Cisco ATA186-I1 Administrator's Manual

Software Features

Additional Supported Signaling Protocols

In addition to SCCP, the Cisco ATA supports the following signaling protocols:
•
•
•
If you wish to perform a cross-protocol upgrade from SCCP to another signaling image, see
"Performing a Cross-Protocol Upgrade."

Other Supported Protocols

Other protocols that the Cisco ATA supports include the following:
•
•
•
•
•
•
•
•
•
•

Basic Services

For an alphabetical list of Cisco ATA basic services and the parameters for configuring each service, see
Table 3-5 on page
These services include the following features:
•
•
•
•
•
•
•
•
•
•
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0)
1-6
Media Gateway Control Protocol (MGCP)
H.323
Session Initiation Protocol (SIP)
802.1Q VLAN tagging
Cisco Discovery Protocol (CDP)
Domain Name System (DNS)
Dynamic Host Configuration Protocol (DHCP)
Internet Control Message Protocol (ICMP)
Internet Protocol (IP)
Real-Time Transport Protocol (RTP)
Transmission Control Protocol (TCP)
Trivial File Transfer Protocol (TFTP)
User Datagram Protocol (UDP)
3-8.
Configurable tone (dial tone, busy tone, confirm tone, reorder tone, call waiting tone)
IP address assignment—DHCP-provided or statically configured
Cisco ATA configuration by means of the Cisco CallManager TFTP server, web browser, or voice
configuration menu.
VLAN configuration
Caller ID format
Ring cadence format
Distinctive ring (external calls have two rings with a short pause between rings)
Silence suppression
Low-bit-rate codec selection
RTP media port configuration
Chapter 1 Cisco Analog Telephone Adaptor Overview
Appendix D,
OL-4652-01