Cisco ATA186-I1 Administrator's Manual page 56

Configuring the Cisco ATA Using a TFTP Server
Procedure if DHCP Server is not Under Control of Cisco ATA Administrator
This is the procedure to use if the DHCP server is not under the control of the Cisco ATA administrator,
which means that the URL of the TFTP server must be manually configured.
Procedure
Using the voice configuration menu, set the parameter TftpURL to the IP address or URL of the TFTP
Step 1
server. For more information on setting the TftpURL parameter, see the
For information about using the Cisco ATA voice configuration menu, see the
Menu" section on page
Note
Step 2 If you have an alternate TFTP server that you also want to configure with the Cisco ATA configuration
process, set the AlttftpURL parameter to the IP address or URL of the alternate TFTP server. For more
information about the AlttftpURL parameter, see the
Use the default value of 1 for the Cisco ATA parameter DHCP.
Step 3
Step 4 Use the default value of 1 for the Cisco ATA parameter UseTftp.
Step 5 Use the default value of 0 for the Cisco ATA parameter CA0orCM0.
This completes the parameter settings you need to configure for this procedure. The Cisco ATA will
contact the manually configured TFTP server that contains the Cisco ATA configuration file.
Other DHCP Options You Can Set
The following parameters can also be configured with DHCP:
•
•
•
•
•
DHCP options 43 and 60 are set by the Cisco ATA. Option 43 specifies the protocol and option 60
Note
identifies the vendor class of the Cisco ATA box.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0)
3-20
3-22.
If you are not using a DHCP server to provide the TFTP server location, you must manually
configure the TftfURL. You can do this by using the voice configuration menu without first
obtaining network connectivity for the Cisco ATA. If you want to configure this value using the
Web configuration page, you first must obtain network connectivity by using the voice
configuration menu to statically configure IP address information (see the
Menu" section on page
Boot file name of DHCP header—The ata<macaddress> binary Cisco ATA configuration file,
which can have a maximum of 31 characters and can be any name with printable ASCII characters
Client PC address
DHCP option 1—Client Subnet Mask
DHCP option 3—Routers on the client's subnet
DHCP option 6—One or two Domain Name servers
3-22).
"AlttftpURL" section on page
Chapter 3 Configuring the Cisco ATA for SCCP
"TftpURL" section on page
"Voice Configuration
"Voice Configuration
5-5.
5-4.
OL-4652-01