Table of Contents
Advertisement
Chapter 5
Parameters and Defaults
NumTxFrames
Description
This parameter is not used for SCCP. For information about RTP packet size configuration, which is
controlled by the Cisco CallManager, refer to your Cisco CallManager documentation.
Operational Parameters
This section includes parameters that are used for configuring the connection mode of the Cisco ATA
as well as for disabling or enabling various operational features:
•
•
•
•
•
•
•
•
CallerIdMethod
Description
This 32-bit parameter specifies the signal format to use for both FXS ports for generating Caller ID
format. Possible values are:
•
If method=0, set the following bits:
•
•
•
•
The Cisco ATA supports the Bellcore FSK method to turn on/off the visual message waiting indicator
Note
(VMWI) on a phone when the Cisco ATA receives MWI messages from a server. The Bellcore FSK
VMWI is enabled automatically if the CallerIdMethod parameter is configured to use the Bellcore
method.
OL-4652-01
CallerIdMethod, page 5-17
Polarity, page 5-19
FXSInputLevel, page 5-20
FXSOutputLevel, page 5-20
ConnectMode, page 5-21
SigTimer, page 5-23
OpFlags, page 5-24
TOS, page 5-25
Bits 0-1 (method)—0 (default) =Bellcore (FSK), 1=DTMF, 2=ETSI, and 3 is reserved.
Bit 3 to 8—Use these bits for setting the maximum number of digits in the phone number portion
(valid values are 1 to 20). The default is 12.
Bit 9 to 14—Use these bits for setting the maximum number of digits in the name number portion
(valid values are 1 to 20). The default is 15.
Bit 15—Use the default value of 1 for this bit to send the special character O (out of area) to the
CID device if the telephone number is unknown.
Bit 16—Use the default value of 1 for this bit to send the special character P (private) to the CID
device if the telephone number is restricted.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0)
Operational Parameters
5-17
Advertisement
Chapters
Table of Contents
