Audio Configuration Parameters
Audio Configuration Parameters
This section contains information about the following parameters:
•
•
AudioMode
Description
This parameter is used for the audio operating mode. The lower 16 bits are for the Phone 1 FXS port,
and the upper 16 bits are for the Phone 2 FXS port.
Value Type
Bitmap
Default
0x00350035
Voice Configuration Menu Access Code
312
Related Parameters
•
•
Table 5-1
AudioMode Parameter Bit Definitions
Bit Number
0 and 16
1 and 17
2 and 18
3-15 and 19-31
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0)
5-16
AudioMode, page 5-16
NumTxFrames, page 5-17
LBRCodec, page 5-13
ConnectMode, page 5-21
Definition
Note
These bits are obsolete for SCCP as of Cisco ATA Release 3.0. Silence
suppression, formerly configurable with these bits, must be configured by
means of the Cisco CallManager service parameters page.
0—Enable selected low-bit-rate codec in addition to G.711.
1—Enable G.711 only.
Default: 0
0/1—Disable/enable fax CED tone detection.
Default: 1
Reserved.
Chapter 5
Table 5-1
provides definitions for each bit.
Parameters and Defaults
OL-4652-01