Basic Configuration Steps In A Non-Tftp Server Environment - Cisco ATA186-I1 Administrator's Manual

Steps Needed to Configure the Cisco ATA
Table 3-3 Basic Steps to Configure the Cisco ATA in a Typical Cisco CallManager Environment
Action
Configure the method with which the Cisco ATA will locate the
3.
Cisco CallManager TFTP server at boot up time.
Add the Cisco ATA to the Cisco CallManager.
4.
Power up the Cisco ATA.
5.
Optionally, create a configuration file for a specific Cisco ATA.
6.
If you make configuration changes to the Cisco ATA, you must reset
7.
the Cisco ATA by using the Cisco CallManager administration web
pages.

Basic Configuration Steps in a Non-TFTP Server Environment

Table 3-4
Table 3-4 Basic Steps to Configure the Cisco ATA Without Using the TFTP Server Method
Action
1. Download the desired Cisco ATA release software zip file from the Cisco web site:
a. If you are a registered CCO user. go to the following URL:
http://www.cisco.com/cgi-bin/tablebuild.pl/ata186
b. Download the zip file that contains the software for the applicable release and signaling
image you are using. The contents of each file are described next to the file name.
Extract the files to the desired location on your PC.
c.
Note The file that contains the protocol signaling image has an extension of .zup.
2. Manually upgrade the Cisco ATA to the correct signaling image.
3. Configure the Cisco ATA by using either one of the manual-configuration methods.
Manually configure the CA0orCM0 parameter to instruct the Cisco ATA about how to
4.
register with Cisco CallManager.
Power up the Cisco ATA.
5.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0)
3-6
shows the basic steps for configuring the Cisco ATA without using the TFTP server method.
Chapter 3 Configuring the Cisco ATA for SCCP
Reference
Configuring the Cisco ATA to Obtain its
Configuration File from the TFTP Server, page
3-18
Chapter 4, "Adding the Cisco ATA to the
Cisco CallManager"
Creating a Configuration File for a Specific
Cisco ATA, page 3-11
Resetting the Cisco ATA Using
Cisco CallManager, page 3-26
Reference
Upgrading the Signaling
Image Manually, page 7-4
•
•
CA0orCM0 and
CA1orCM1, page 5-12
Voice Configuration
Menu, page 3-22
Cisco ATA Web
Configuration Page,
page 3-25
OL-4652-01