Cisco ATA186-I1 Administrator's Manual page 59

Chapter 3 Configuring the Cisco ATA for SCCP
Table 3-7
Voice Menu
Number
1
2
10
20
21
22
23
Follow the voice prompts and enter the appropriate values, then press the # key.
Step 4
Note
Note
The voice configuration menu repeats the value you entered, then prompts you to press one of the
following keys:
1=Change your entered value
•
2=Review your entered value
•
• 3=Save your entered value
• 4=Review the current saved value
Step 5 Cisco strongly recommends that you set a password. Use the voice menu code 7387277 (SETPASS) to
configure a password through the voice configuration menu, after which you are prompted for the
password whenever you attempt to change a parameter value.
After completing the configuration through the voice configuration menu, press the # key to exit.
Step 6
Step 7 Hang up the telephone. The Cisco ATA configuration refreshes. The function button fast-blinks when
the refresh is completed.
OL-4652-01
Parameters that Provide Basic IP Connectivity for the Cisco ATA
Features
StaticIP—IP address of the Cisco ATA.
StaticRoute—Default gateway for the Cisco ATA to use.
StaticNetMask—Subnet mask of the Cisco ATA.
DHCP—Set value to 0 to disable the use of a DHCP server; set value to 1 to enable
DHCP.
Review the IP address of the Cisco ATA.
Review the default router for the Cisco ATA to use.
Review subnet mask of the Cisco ATA.
Use the * key to indicate a delimiter (dot). For example, to enter an IP address of 192.168.3.1,
you would enter 192*168*3*1 on your telephone keypad.
When entering values for a field that contains a hexadecimal value, you must convert the
hexadecimal value to a decimal value in order to enter it into the voice configuration menu
system. For example, to enter the hexadecimal value 0x6A, you would enter the number 106 on
the telephone keypad.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0)
Voice Configuration Menu
3-23