Chapter 5
Parameters and Defaults
•
•
•
Voice Configuration Menu Access Code
925
Diagnostic Parameters
This section describes the following parameters that are used for diagnostic purposes:
•
•
•
•
NPrintf
Description
Use this parameter to specify the IP address and port of a host to which all Cisco ATA debug messages
are sent. The program prserv.exe, which comes bundled with the Cisco ATA software, is needed to
capture the debug information.
Syntax
<HOST_IP>,<HOST_PORT>
Example
If the program prserv.exe is running on a host with IP address 192.168.2.170 and listening port 9001, set
NPrintf to 192.168.2.170.9001. This causes the Cisco ATA to send all debug traces to that IP address.
Value Type
Extended IP address
Default
0
Voice Configuration Menu Access Code
81
Related Parameter
TraceFlags, page 5-38
OL-4652-01
OnTime—480
OffTime—480
TotalToneTime—1920
NPrintf, page 5-37
TraceFlags, page 5-38
SyslogIP, page 5-38
SyslogCtrl, page 5-39
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0)
Diagnostic Parameters
5-37