Configuring Cisco Ios Gateways To Enable Fax Pass-Through; Enable Fax Pass-Through Mode - Cisco ATA186-I1 Administrator's Manual

Using Fax Pass-through Mode

Configuring Cisco IOS Gateways to Enable Fax Pass-through

To configure your IOS gateways to network with Cisco ATA, do the following:
Procedure
Step 1 Enable Fax Pass-through Mode, page 6-4
Step 2 Disable Fax Relay Feature, page 6-6
For detailed information on setting up your IOS gateways and on feature availability, refer to the
Note
document Cisco Fax Services over IP.

Enable Fax Pass-through Mode

The supporting Cisco gateway can enable fax pass-through mode using system-level or dial-peer-level
commands.
System Level commands
Enable the fax pass-through feature using the following system-level commands:
Procedure
Run the following command:
Step 1
voice service voip
Run the following command:
Step 2
modem passthrough NSE [payload-type number] codec {g711μ/law | g711alaw} [redundancy]
[maximum-sessions value]
The definitions of the command parameters are as follows:
•
•
•
•
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0)
6-4
The payload-type parameter default is 100. Valid values are from 98 to 119.
The NSE payload number must be the same on both the Cisco ATA and the Cisco gateway.
The codec parameter must be G.711μ− law for faxes sent over a T1 trunk or G.711A-law for faxes
sent over an E1 trunk.
The redundancy parameter enables RFC 2198 packet redundancy. It is disabled by default.
The maximum sessions parameter defines the number of simultaneous fax pass-through calls with
redundancy. The default is 16. Valid values are 1 to 26.
Chapter 6 Configuring and Debugging Fax Services
OL-4652-01