Without Using A Dhcp Server - Cisco ATA186-I1 Administrator's Manual

Chapter 3 Configuring the Cisco ATA for SCCP

Without Using a DHCP Server

Use the following procedure if you are not using a DHCP server in your environment but are still using
a TFTP server to obtain the Cisco ATA configuration file:
Procedure
Set the DHCP parameter to 0.
Step 1
Set the UseTftp parameter to 1.
Step 2
Set the Cisco ATA parameter TftpURL to the IP address or URL of the TFTP server. For more
Step 3
information on setting the TftpURL parameter, see the
Note
If applicable, set the Cisco ATA parameter AlttftpURL to the IP address or URL of the alternate TFTP
Step 4
server. For more information about the AlttftpURL parameter, see the
page
Step 5 If you have not already done so, statically configure the following parameters using the voice
configuration menu (see the
parameters you need to configure for the Cisco ATA to obtain network connectivity:
•
•
•
Other parameters that are normally supplied by DHCP may be provided statically by configuring their
values. These parameters are:
•
•
•
This completes the parameter settings you need to configure in order for the Cisco ATA to contact the
TFTP server (without using DHCP) that will contain the configuration file for the Cisco ATA.
OL-4652-01
If you are not using a DHCP server to provide the TFTP server location, you must manually enter
the TftpURL using either the voice configuration menu or the web configuration page.
5-5.
"Voice Configuration Menu" section on page
StaticIP
StaticRoute
StaticNetMask
DNS1IP
DNS2IP
Domain
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0)
Configuring the Cisco ATA Using a TFTP Server
"TftpURL" section on page
"AlttftpURL" section on
3-22). These are the
5-4.
3-21