Table of Contents
Advertisement
Procedures for Using Mid-call Services
MeetMe Conference
To use this feature, follow these steps:
Procedure
Step 1
Pick up the handset, press ** then 5 on your telephone keypad. You are prompted to enter a MeetMe
Conference number to reserve a conference.
Step 2
When someone dials the MeetMe Conference number, you receive a confirmation tone and can begin
conferencing with the caller.
Procedures for Using Mid-call Services
The method of initiating and using mid-call services during a call when using SCCP differs according
to mode, which is configured by the Cisco ATA administrator using the ConnectMode parameter (see
the
configured on your Cisco ATA.
The following three modes are used for invoking mid-call services:
•
•
•
Bellcore Style
The following two procedures are unique to the Bellcore (default) style:
•
•
Bellcore Style Call Transfer Procedure
Perform a hook flash to place the current call on hold and obtain a second dial tone.
Step 1
Step 2
At the dial tone, enter the telephone number or speed dial of the third party and wait for the call to ring.
Step 3
You have the following options:
•
•
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0)
A-4
"ConnectMode" section on page
Bellcore Style, page A-4
Cisco VG248 Style, page A-5
Cisco ATA Style, page A-6
Bellcore Style Call Transfer Procedure, page A-4
Bellcore Style Conference Call Procedure, page A-5
To transfer the call, hang up when the call rings or when the third party answers.
To return to the original call, perform a hook flash before the call rings. If you perform a hook flash
before the third party answers but after the call rings, you also return to the original call.
Appendix A
5-21). Use the procedures for the mid-services mode that is
How to Use Pre-call and Mid-call Services
OL-4652-01
Advertisement
Chapters
Table of Contents
