Table of Contents
Advertisement
Chapter 5
Parameters and Defaults
Range
-9 to 2 dB
Default
-4
Voice Configuration Menu Access Code
371
Related Parameter
FXSInputLevel, page 5-40
Tone Configuration Parameters
The Cisco ATA supports the following tone parameters:
•
•
•
•
•
•
The Cisco ATA supports two types of tone-parameter syntax—basic format and extended format. Basic
format is used in most countries; use the extended format only if the country in which the Cisco ATA is
used requires this format.
This section covers all the call-progress tones that the Cisco ATA supports, and contains the following
topics:
•
•
•
•
This section also covers the following parameter, which is for configuring phone-ringing characteristics:
•
For detailed recommendations of tone-parameter values by country, see
Note
Cisco ATA Tone Parameter Values by Country."
Tone Parameter Syntax—Basic Format
Each tone is specified by nine integers, as follows:
parametername: NumOfFreqs,Tfreq1,Tfreq2,Tamp1,Tamp2,Steady,OnTime,OffTime, TotalToneTime
•
OL-4804-01
DialTone
BusyTone
ReorderTone
RingBackTone
CallWaitTone
AlertTone
Tone Parameter Syntax—Basic Format, page 5-41
Tone Parameter Syntax—Extended Formats, page 5-43
Recommended Values, page 5-48
Specific Tone Parameter Information, page 5-48
RingOnOffTime, page 5-51
parametername is the name of the tone.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for H.323 (version 3.0)
Tone Configuration Parameters
Appendix E, "Recommended
5-41
Advertisement
Table of Contents
