ATA Routing Field Reference
Application page
Application page
ATA Administration Guide
Router tab > LAN Setup page >
LAN Networking Settings section
Use these network settings when using NAT.
LAN IP Address
LAN Subnet Mask
Enable DHCP Server
DHCP Lease Time
DHCP Client Starting IP
Address
Number of Client IP
Addresses
Router tab > LAN Setup page >
Static DHCP Lease Settings section
Use these settings when using a static IP address.
Enable
Host Mac Address
Host IP Address
You can use the Application page to set up port forwarding, DMZ, and multicast
passthrough, and to reserve ports. This page includes the following sections:
•
"Port Forwarding Settings section," on page119
•
"DMZ Settings section," on page119
•
"Miscellaneous Settings section," on page120
•
"System Reserved Ports Range section," on page120
IP address of the ATA device on the LAN side.
IP address for subnet mask.
Options are Yes or No for the DHCP Server to provide
an IP address.
Provided by the DHCP Server. IP renewal process
begins when the time expires.
Initial IP address the DHCP Server provides for PCs
attached to the LAN port.
Number IP addresses available for the DHCP Server to
provide.
Options are Yes or No. Default is No.
Match to other device's MAC address.
Match to other device's IP address.
A
118