Additional Supported Signaling Protocols; Other Supported Protocols; Cisco Ata Sip Services - Cisco ATA-186 Administrator's Manual

Software Features

Additional Supported Signaling Protocols

In addition to SIP, the Cisco ATA supports the following signaling protocols:
•
•
•
SIP and H.323 share the same software image. SCCP and MGCP also share a software image, which is
separate from the SIP/H.323 image. If you wish to perform a cross-protocol upgrade from SIP to another
signaling image, see the

Other Supported Protocols

Other protocols that the Cisco ATA supports include the following:
•
•
•
•
•
•
•
•
•
•

Cisco ATA SIP Services

For a list of required SIP parameters as well as descriptions of all supported Cisco ATA SIP services and
cross references to the parameters for configuring these services, see
SIP Services."
These services include the following features:
•
•
•
•
•
•
•
•
•
•
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide (SIP)
1-8
H.323
Skinny Client Control Protocol (SCCP)
Media Gateway Control Protocol (MGCP)
"Upgrading the Signaling Image from a TFTP Server" section on page
802.1Q VLAN tagging
Cisco Discovery Protocol (CDP)
Domain Name System (DNS)
Dynamic Host Configuration Protocol (DHCP)
Internet Control Message Protocol (ICMP)
Internet Protocol (IP)
Real-Time Transport Protocol (RTP)
Transmission Control Protocol (TCP)
Trivial File Transfer Protocol (TFTP)
User Datagram Protocol (UDP)
IP address assignment—DHCP-provided or statically configured
Cisco ATA configuration by means of a TFTP server, web browser, or voice configuration menu.
VLAN configuration
Cisco Discovery Protocol (CDP)
Low-bit-rate codec selection
User authentication
Configurable tones (dial tone, busy tone, alert tone, reorder tone, call waiting tone)
Dial plans
Network Address Translation (NAT) Gateway
NAT/Port Address Translation (PAT) translation
Chapter 1 Cisco Analog Telephone Adaptor Overview
Chapter 4, "Basic and Additional
8-1.
OL-3410-01