Replacing The Projector-Part Number Cts-Prjtr-Gen1; Replacing A Pdu-Part Number Cts-Pwr-Pdu - Cisco 3200 Use And Care Manual

Chapter 12 Field-Replaceable Unit Guide
d.
e.
Replacing the Projector—Part Number CTS-PRJTR-GEN1=
Step 1 Power off the projector by turning off the power switch located on the back of the unit.
Step 2 Unplug the VGA cable, power cable and serial cable from the rear of the unit.
Remove two of the six screws that hold the projector assembly to the underside of the center tabletop.
Step 3
These screws are the rear-most of the six screws and the farthest away from the projector lens.
Loosen the remaining four mounting screws.
Step 4
Remove the projector assembly by sliding the unit to the front until the projector mounting bracket
Step 5
disengages from the loosened mounting screws.
Step 6 Remove the screws that attach the mounting plate to the projector and remove the plate.
Attach the mounting plate to the replacement projector.
Step 7
Reattach the assembly to the underside of the tabletop.
Step 8
Reattach the VGA cable to the projector.
Step 9
Reattach the power cable to the projector.
Step 10
Reattach the serial cable to the auxiliary control unit.
Step 11
Power on the projector by turning on the power switch located on the back of the unit.
Step 12
Perform first-time setup procedures for the projector by completing the steps in the
Step 13
Projector" section on page
Replacing a PDU—Part Number CTS-PWR-PDU=
There are seven PDUs in the following places:
•
•
•
•
•
On the PDU to be replaced, turn the power switch to Off and remove the plug from the wall receptacle.
Step 1
Remove any cables plugged into the PDU.
Step 2
OL-14521-01
When you are prompted to reset the lamp counter, Select Yes and press the OK button.
Select Yes and press the OK button to reconfirm your choice.
10-20.
Two PDUs attached to the left accessory cabinet
One PDU attached to the right accessory cabinet
One PDU attached to the underside of the first row tabletop, on the center privacy panel
One PDU in the cable gutter on the second row table section, Section 4 (second from the left)
One PDU in the cable gutter on the second row table section, Section 3 (second from the right)
Replacing the Projector—Part Number CTS-PRJTR-GEN1=
Cisco TelePresence System 3200
"Setting Up the
12-27