Setting The Menu Password - Cisco Profile Series Getting Started Manual

Profile Series, Codec C Series and Quick Set C20 / C20 Plus
Contents Introduction

Setting the menu password

The Administrator settings menu can be password protected.
When turning on the codec for the first time, the password is
not set. If a menu password has been set you will be asked to
enter a password to get access to the Administrator settings
menu.
Read more about password protection in chapter 6,
Password protection.
Profile Series, Codec C Series and Quick Set C20/C20 Plus Getting Started Guide TC4.1, Feb 2011.
D14639.03
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
Configure your system Operating devices
HOME
Call
Presentation
Camera control
Settings
Layout
Main source: Main camera
Call settings
Languages
Date and time
Sounds and alerts
Wallpaper: Custom
System information
Administrator settings
Restart
Please enter your
Menu password:
***
OK
Cancel
If the Administrator settings menu is password
protected, type in the password and press OK
to proceed or Cancel to go back one step in
the menu.
17
The menu system The menu system
SETTINGS
Programmable softbuttons
Connect to Cisco Callway
IP settings
Advanced configuration
PASSWORD
Set menu password
Getting started guide
The web interface Password protection
Setting a new password
Go to the Set menu password menu and:
On the remote control, press the # key to
toggle between lower or upper case characters
and numbers: abc/ABC/123
Enter the password. The password you enter is
hidden, and each character is replaced with a
star (*).
Navigate to Save and press OK ( ) to save the
changes, or Cancel to leave without saving.
Press Home ( ) to exit.
ADMINISTRATOR SETTINGS
SET PASSWORD
Password
***
Save
Cancel
www.cisco.com