6: Slc Family; Jumpstart Autoprogramming - Honeywell Silent Knight SK318PT Installation And Operation Manual

4. Select 7 for Edit Banner.
NOTE: See Appendix B for instructions on how to edit the banner.
5. Select each letter by pressing the up or down arrow, then press the right arrow to move to the next character.
6. When done, press ENTER to move to line two of the custom banner.
9.6.6 SLC Family
The 6820/6820EVS supports SD protocol SLC devices or SK protocol SLC devices. You must configure the 6820/6820EVS to accept
the protocol of the devices you are installing.
NOTE: You cannot mix SK and SD protocol SLC devices on the same panel
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Program Menu.
3. Select 5 for System Options.
4. Press 8 for SLC Family.
5. Press Up arrow to select the desired SLC device type.
6. Press ENTER to accept the displayed SLC device type.
NOTE: When changing SLC type from one protocol to another, the following message will appear.
NOTE: Message when changing SLC family from SK to SD: "Changing to this SLC family will remove all external 6815's"
NOTE: Message when changing from SD to SK: "SLC family will remove all 5815XL's on the system"

9.7 JumpStart AutoProgramming

Panels support an incremental JumpStart. For Example: After initial JumpStart & customization, if you add more devices, when you
JumpStart again the additional devices are added but you do not lose any of your previous custom programming
To run JumpStart:
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Panel Programming.
3. Select 6 for JumpStart.
4. Press ENTER to accept the warning screen.
5. Follow the remaining on screen instructions.
6. Press ENTER to confirm. See Section 8.1.3.
132
Figure 9.11 SLC family change
6820 / 6820EVS Manual P/N LS10144-001SK-E:C 09/28/2017