4.
Attach the annunciator and door assembly to back box as shown in Figure 4.19 using the supplied screws.
Surface Mounting
The optional Model RA-100TG/TR trim ring kit is available for use when surface mounting.
1.
Remove the desired knock out.
2.
To properly mount the back box, insert a single screw into the key shaped mounting hole. Do not tighten all the way. See
Figure 4.20.
Place a level on top of the back box, with the back box level insert the rest of the mounting screws.
3.
Run wires to the control panel.
6820 / 6820EVS Manual P/N LS10144-001SK-E:C 09/28/2017
Figure 4.19 Attaching Annunciator/Door Assembly to Backbox
Key Shaped
Mounting Hole
Figure 4.20 Back Box Surface Mount Holes
Back Box
Mounting Holes
41