1: Mounting The 5860 - Honeywell Silent Knight SK318PT Installation And Operation Manual

4.5.1 Mounting the 5860
This section of the manual describes mounting the remote annunciator. The annunciator can be flush- or surface-mounted. Figure 4.11
shows the parts of the annunciator. Instructions for disassembling and mounting appear on the following pages.
The 5860 comes from the factory fully assembled. You must disassemble it for mounting. To disassemble the annunciator, use a 5/64 hex
wrench to remove the set screws, located on the bottom of the annunciator bezel. (See Figure 4.12 for location of the set screws).
36
Figure 4.11 Annunciator Parts
Holes for surface mounting.
Holes for inserting
wires for flush mounting
(located in all corners).
Set screw location.
Loosen set screws to remove bezel
when disassembling annunciator.
Figure 4.12 Annunciator Back Box and Bezel Details
Knockout holes
Stand-off
(throughout)
Screw for placement
of mounting wires
(top and bottom).
6820 / 6820EVS Manual P/N LS10144-001SK-E:C 09/28/2017