Cisco 6800 Series Administration Manual page 77

Phone Administration
What to do next
After you set up the alarm profile alias, go to
alarms to each handset that requires the alarm. You need to set the Alarm Profile and configure the Alarm
Line and Alarm Number fields. After you set up alarms on a handset, you need to reboot the handset.
Configure Emergency Numbers
You may want to change the settings in the Emergency Numbers table in the Management web page. These
fields control the numbers that are associated with emergency calls.
Make sure that your users are familiar with the emergency numbers. Your users can dial these numbers even
if the keypad is locked.
Before you begin
Connect to the base station web page as described in
Procedure
Step 1
Click Management.
Step 2 Configure the emergency numbers, as described in the Emergency Numbers table in
Fields, on page
Step 3 Click Save.
Temporary Handset Addition to the Base Station
You can register a handset temporarily to the base station in promiscuous mode. The base station can be in
promiscuous mode when it's factory reset. The promiscuous mode is active for 255 minutes when enabled
from the Management web page or configuration file (.xml), or 5 minutes when you press the base station
Reset button. You can add the unregistered handsets to the base station and update the handsets.
The base station downloads the configuration file from the CDA or DHCP server to update the handsets. If
the server requests authorization, you enter the username and password with the handset. If the base station
doesn't have the
code that you enter with your handset.
The handsets deregister when the promiscuous mode times out. If any handset update is in progress, the timer
is reset.
You can enable the promiscuous mode in these ways:
• Configuration file or Management web page. For more information, see
• Reset button. For more information, see
104.
<profile_rule>
from the Firmware, on page
on page 70
Change the Handset Information, on page 53
Sign in to the Administration Web Page, on page 42
set in the configuration file, the CDA server requests the short activation
70.
Turn On Promiscuous Mode with the Base Station Reset Button,
Cisco IP DECT 6800 Series Administration Guide
Configure Emergency Numbers
and assign the
Management Web Page
Turn On Promiscuous Mode
69