Cisco 6800 Series Administration Manual page 130

Multi Cell Web Page Fields
Field
Primary Data Sync IP
Multi cell debug
After you set the Multi cell system field to Enabled, and reboot the base station, a message displays on the
page.
Table 49: DECT system settings
Field
RFPI System
Cisco IP DECT 6800 Series Administration Guide
122
Contents Description
IP address Indicates the base station data synchronization IP
address.
Using multicast, this base IP is selected automatically.
The data sync feature uses the port range 49200 to
49999
Note
Note
Values: Indicates the level of multicell debugging information
is stored in the logs.
• None (default)
• Data Sync
• Auto Tree
• Both
Contents Description
Displays the radio identity that all the base stations
use for the multicell system.
Using Peer to Peer mode, the IP of the base
used for data sync source MUST be
defined.
Using Peer to Peer mode with version
below V306 limits the system automatic
recovery feature. There is no automatic
recovery of the data sync source in Peer to
Peer mode.
• None (default)—No d
• Data Sync—Writes header information for all
packets received and sent to be used to debug
any special issues.
Note This setting generates many logs, so
use it for a short period of time when
debugging.
• Auto Tree—Writes states and data related to the
Auto Tree Configuration feature.
• Both—Both Data Sync and Auto Tree are
enabled.
This setting generates many logs, so
Note
use it for a short period of time when
debugging.
Monitoring